|
|
|
|
|
|
This is a link to the old forums.
www.buckmasters.com/forum |
| | Author | Messages | |
hrodrig1 - 
Button Buck
New Jersey
 | | 09/04/2007 6:10 AM |
| | If Iam missing the bull zie a little to the left, do I move my sight left or right? | | | |
| eversboys -
Spike
Pineville Louisiana
| | 09/04/2007 6:37 AM |
| | Always move the sight towards your arrows. Hitting right, move right, Hitting left, move left. | |
move once, ive gotcha
move twice, youre dead | |
| r_rayjr -
4-Pointer
Council Bluffs, Iowa
| | 09/04/2007 6:50 AM |
| Yes, and remember that if your screws are at the bottom like mine is, and you leave the bow upside down while you make your adjustment, move it in the opposite direction.
I did this and the shot kept getting worse, then I relized why, bow upside down you have to move left if the arrown is right...
But if you loosen the scew and keep the bow in the up-right position then like eversboys said, arrow right, move sight right. | |
Ronald Lee Ray Jr.
rrjr11@cox.net
Disabled Navy Veteran | |
| Rilla -
Button Buck
New Iberia, Louisiana
| | 09/04/2007 12:04 PM |
| | Always move towards your arrow. | |
7MM Rem. Mag. reach out and touch something!! | |
| kitterick -
Button Buck
| | 09/04/2007 6:11 PM |
| moving your sight to the left means you wont have to move the bow as far left when you line it up (after the adjustment)\\
make sence? | |
DRENALIN
SIDEWINDER LX
AXIS ST
G5 STRIKER | |
| stillframe -
Button Buck
SC
| | 09/04/2007 6:43 PM |
| Was the bow Ever hitting on target?
Be sure it's the sight that needs adjusting and not your technique... If the bow was ever set up right and shots are off now the shooter may have changed a seemingly minor habit without realizing it. I have had days when I was shooting perfect groups in the morning and the same groups fly off center that evening... I put the bow down and started again after supper and was right back on target. Never did figure out what I was/wasn't doing but I hope it doesn't happen when it counts.
| | | |
| hrodrig1 -
Button Buck
New Jersey
| | 09/05/2007 8:10 AM |
| | I just bought a new browning and Iam missing an inch or two wide left from dead center of target. My group is fine but why Iam i missing left. Iam going to shot this afternoon and see what happens after I move my sight a little bit. Thank You all for your help | | | |
| emmac13 -
Button Buck
| | 09/06/2007 4:01 PM |
| | Good Luck. Tighten the screws. Just don't over tighten or OOOOOPPPPPS. I hate that. I always battle myself not to strip threads. | | | |
|
| | You are not authorized to post a reply. |
|
| |
| |
|
|
|
|
|
|
|
|
Copyright 2008 by Buckmasters LTD. |
|
|