|
|
|
|
|
|
This is a link to the old forums.
www.buckmasters.com/forum |
| | Author | Messages | |
2chucks - 
Spike
 | | 09/29/2007 1:32 PM |
| I have not yet been able to get out into the woods yet this year with my bow and I am itching to try these new broadheads I made. I am really curious about the single bevel blades and what they will do.
As luck would have it, a neighbor brought me a fresh archery kill to process for him. I asked him if it would be ok to test my heads on his deer. He didn't mind since he wanted the whole deer ground into sausage and/or burger. So here she is. All 68 pounds of her (dressed) I would have loved to be trying this on a 150 pound deer but beggars can't be choosers. 
I made three shots from 10 yards with my 45 pound longbow that shoots an arrow at a blazing 142 FPS. the first two were through the ribs and the final one hit the shoulder blade at the point where the flat and the "T" meet, right near the ball joint. This is (in my opinion) the largest and thickest bone section in the upper shoulder. I admit that hitting this far forward is not a good place to aim on a live animal but things happen beyond our control. I of course hit this spot with pin point precision on purpose . 
The rib shots were complete pass throughs but the shoulder shot ended up with just the fletches sticking out entrance side. I know there were no lungs in the deer but they don't offer much in the way of resistance any way. Also consider that this deer was cold and stiff as rigor mortise had set in so I consider all things equal.
Right off the bat, I noticed the "S" shaped cuts that Dr. Ashby had spoke about. This was the case on both the entrance and exit holes.
*** Word of caution***
When you pull the arrow back out of the deer (through a bone) and you have sharpened your broadheads on the trailing edge as well as the main edge. Make sure to keep your fingers clear even though you need to hold the deer steady while retrieving the arrow. 
After a brief bit of first aid, I began to skin the deer, I noticed that both of the rib shots had completely missed hitting ribs on both sides. My goal was to break a rib to see the results but I must have used up all my luck..... I mean skill on that shoulder shot.
I then removed the shoulder and boned it out.
Just as described by Dr. Ashby, the "S" shaped cut and the bone had split completely being held at the joint end by only some soft fibers.
As expected, the single bevel head is a real bone breaker/spliter. I know this is a very small deer but again, I was using a rather low power bow. Take from this what you will but I am even more pleased with the single bevel heads. This sort of thng is not nessesary with todays super fast and powerfull bows huntinh whoitetails but for those using traditional archery gear, or those going after large or dangerus game, we are looking for every advantage we can get.
| | | |
| cb -
6-Pointer
| | 09/29/2007 3:18 PM |
| Impressive! and I learned something today.
Thanks for the info. | | | |
| pjk8867 -
Button Buck
Utah
| | 09/30/2007 5:39 PM |
| Nice demo 2Chucks.
Very interesting.
PJK | |
May the hunting Gods be with you. | |
| WANTABIGBUCK -
6-Pointer
SCOTTSVILLE, VA.
| | 10/02/2007 12:03 PM |
| | GREAT GOING AND CONGRATS TO YA | | | |
|
| | You are not authorized to post a reply. |
|
| |
| |
|
|
|
|
|
|
|
|
Copyright 2009 by Buckmasters LTD. |
|
|